Shopsmith Forums • How did these work on legs.

Page 1 of 1

How did these work on legs.

Posted: Wed May 06, 2020 10:04 pm

by BobCoates1953

All the pictures I have seen these would not work. I picked up two sets of these and used one on radial arm saw.
On saw.

: Caster4.jpg (16.29 KiB) Viewed 6471 times

Extra set. Only one caster and rod shown.

: Caster3.jpg (17.18 KiB) Viewed 6471 times

Re: How did these work on legs.

Posted: Thu May 07, 2020 1:10 am

by rpd

Those were for the Mark VII made in the 60's, the base and caster setup is very different than on Mark V's
https://www.shopsmith.com/ss_forum/view ... 90#p187888

Re: How did these work on legs.

Posted: Thu May 07, 2020 12:16 pm

by BobCoates1953

Thanks,
Never saw that type of base, If anyone needs the extra set for VII let me know by private email.

Bob

Re: How did these work on legs.

Posted: Sun May 31, 2020 11:20 pm

by JPG

I sent you a PM.