Rockler T-Track Inline clamps have found a home in my shop
Posted: Sun Sep 06, 2020 9:00 pm
You can read about them here:
https://www.rockler.com/rockler-t-track ... -cam-clamp
You might also what to check out these Omni Stops:
Rockler Omni Stop for T-Track Table
https://www.rockler.com/rockler-omni-st ... rack-table
The clamps are more of a toggle then I had hoped for but I still think they will be useful for me. They are also higher then I would like but again there are work around to be had so all is good.
I built some added platforms for my Shaper Origin workstation using the same Rockler t-track that has sort of become my de-facto standard. Here are a couple of pictures showing the clamps on my platforms.
This second shot shows the workaround I mentioned.
Not going to be for everyone at that price point but for me it adds some more options that will be useful for my work flow.
Ed
https://www.rockler.com/rockler-t-track ... -cam-clamp
You might also what to check out these Omni Stops:
Rockler Omni Stop for T-Track Table
https://www.rockler.com/rockler-omni-st ... rack-table
The clamps are more of a toggle then I had hoped for but I still think they will be useful for me. They are also higher then I would like but again there are work around to be had so all is good.
I built some added platforms for my Shaper Origin workstation using the same Rockler t-track that has sort of become my de-facto standard. Here are a couple of pictures showing the clamps on my platforms.
- roc1.jpg (159.77 KiB) Viewed 1658 times
- roc2.jpg (155.42 KiB) Viewed 1658 times
Not going to be for everyone at that price point but for me it adds some more options that will be useful for my work flow.
Ed