Page 1 of 1
Way tube table
Posted: Thu Nov 05, 2020 4:56 pm
by lewparsell
I am looking for plans or pictures of an auxiliary table sits on top of the way and interlocks below them I have seen it in a YouTube video so I know it can be done. I have a compound miter saw and separate jigsaw that I would like to use it, it would also allow me to use the existing shopsmith tables for sport.
I have seen it in a YouTube video
Re: Way tube table
Posted: Thu Nov 05, 2020 5:12 pm
by RFGuy
Does this help? See picture in thread linked below:
viewtopic.php?t=14688
Re: Way tube table
Posted: Thu Nov 05, 2020 8:12 pm
by benmcn
Here is a link that may provide some more information on how Doug Reid made the miter saw base
https://shopsmithwoodworker.com/2013/10 ... -chop-saw/
Another option can be found here
viewtopic.php?p=95179
Here is the video where Doug introduces his miter saw base ( starts around the 4 minute mark)
https://www.youtube.com/watch?v=icYEDQa5Xio
Re: Way tube table
Posted: Fri Nov 06, 2020 2:02 am
by lewparsell
Thanks everyone I will reach out to Doug and see about getting his plans. Very helpful information.
Re: Way tube table
Posted: Wed Dec 02, 2020 12:24 pm
by juankax
What is the dove-tail shaped groove that is now covered up on the bottom used for?
Re: Way tube table
Posted: Thu Dec 03, 2020 11:49 am
by Hobbyman2
If you have a 2nd carriage and table you could all ways set it up to be adjustable and it can be locked down , a fence can be locked down to the table extension and used as a stop . my .02