610 Jigsaw height
Posted: Sat May 15, 2021 1:01 am
How tall are the posts that come with the 610 supposed to be? Mine are about 7.5" but then they are not actually tall enough to align with the top/back drive shaft even at the tallest height. I had some other, offset posts in a box I got with my Mark V that are about an inch taller but even they barely reach the tightening handle on the base and only if I pull them down about 1/2 inch inside the bottom of the jigsaw. It all tightens up like this but I don't imagine it is supposed to work this way.
From the photos below you can see the 7.5" post is barely longer than the gap between the base and the drive shaft.
Thanks!
From the photos below you can see the 7.5" post is barely longer than the gap between the base and the drive shaft.
Thanks!