Page 1 of 3
Wiring on Emerson 1 1/8hp
Posted: Tue Jul 06, 2021 10:56 am
by flyguysr5
Took mine apart to clean the contacts and my pics on wiring placement got deleted. Can someone describe where each wire goes? Only one blue that has a narrow spade connector is a given. thanks
Re: Wiring on Emerson 1 1/8hp
Posted: Tue Jul 06, 2021 1:36 pm
by chapmanruss
On Everett's google drive is a document called MOTOR GUIDE which may be of some help. It is at the link below.
https://drive.google.com/drive/folders/ ... 0Jib6u7NNO
I don't recall which motors I have in my 2 Mark V headstocks and it would require some work to check and get pictures. Right now I am unable to work in my shop due to an injured knee.
Re: Wiring on Emerson 1 1/8hp
Posted: Tue Jul 06, 2021 3:10 pm
by flyguysr5
Russ,
Looked through all of those with no luck on my particular model. Still looking.......
Re: Wiring on Emerson 1 1/8hp
Posted: Tue Jul 06, 2021 3:36 pm
by JPG
Picture!!!
Re: Wiring on Emerson 1 1/8hp
Posted: Tue Jul 06, 2021 5:10 pm
by flyguysr5
JPG, I can not get your pic to open. I have the program so it should. Can you try a different format? Sorry to be such a pain....
Re: Wiring on Emerson 1 1/8hp
Posted: Tue Jul 06, 2021 5:30 pm
by RFGuy
flyguysr5 wrote: Tue Jul 06, 2021 5:10 pm
JPG, I can not get your pic to open. I have the program so it should. Can you try a different format? Sorry to be such a pain....
JPG is requesting you post a picture of your motor, etc. Pictures are tremendously helpful when requesting help on this forum, but often new members don't post them which makes it difficult to give them help.
Re: Wiring on Emerson 1 1/8hp
Posted: Thu Jul 08, 2021 4:53 pm
by flyguysr5
Pics of motor
![Image]()
Re: Wiring on Emerson 1 1/8hp
Posted: Thu Jul 08, 2021 9:09 pm
by JPG
Need a pix of the other side of the start switch board looking in from the outside of the motor end cap.
Also the terminal end of the start capacitor.
Re: Wiring on Emerson 1 1/8hp
Posted: Mon Jul 12, 2021 3:22 pm
by flyguysr5
New pics per request. Maybe this will help me with the wire locations.
Re: Wiring on Emerson 1 1/8hp
Posted: Mon Jul 12, 2021 3:47 pm
by JPG
Yes that helps. Will scope it out later today.
May need a couple of continuity checks on the wires, but hopefully not.