Page 2 of 2
Re: Need Help Identifying Lathe Chuck
Posted: Wed Jul 14, 2021 1:24 pm
by RFGuy
JPG wrote: ↑Wed Jul 14, 2021 12:50 pm
Have you tried all 16 combinations? 8 if keeping jaw sequence(s).
Not yet. I was going to experiment with it one more time before giving up, so your suggestion is a good one. It'll just be slow. I need to attach/detach each jaw and document it as I go. It shouldn't be too bad, just a bit time consuming.
Re: Need Help Identifying Lathe Chuck
Posted: Fri Jul 16, 2021 11:35 am
by chapmanruss
If it does end up that the jaws are out of sequence and you find the correct one it would be a good time to etch numbers on the jaws and head for future reference.