Re: Pulled out my Mini Sled for some Tiny Drawers
Posted: Thu Nov 04, 2021 7:28 pm
Looking good! Front panel ?????
Shopsmith Forums
A woodworking forum for woodworking hobbyist and woodworking projects related and unrelated to the Shopsmith MARK V
https://forum.shopsmith.com/
Pulled out my Mini Sled for some Tiny Drawers
Page 2 of 2
Re: Pulled out my Mini Sled for some Tiny Drawers
Posted: Thu Nov 04, 2021 8:22 pm
That’s some nice looking Therapy! :-)
Re: Pulled out my Mini Sled for some Tiny Drawers
Posted: Sat Nov 06, 2021 10:09 am
Thanks, All!
JPG: I usually love the front panel fabrication step on a restoration, but here I decided to omit both the front panel and the top-handle. This chest is for my personal stash of watch-tinkering stuff. The sharp-eyed will also note that I made the bottom drawer-fascia deep enough to prevent uner-storage of a front-drop panel as well.
All that remained was oiling the wood, sharpening my Exacto knife (on the Powr-Strop wheel added to the Shopsmith), fitting the felt, and fitting a ton of miniature junk into the chest (and its neighbor)
.
Thanks for watching!
Chris
JPG: I usually love the front panel fabrication step on a restoration, but here I decided to omit both the front panel and the top-handle. This chest is for my personal stash of watch-tinkering stuff. The sharp-eyed will also note that I made the bottom drawer-fascia deep enough to prevent uner-storage of a front-drop panel as well.
All that remained was oiling the wood, sharpening my Exacto knife (on the Powr-Strop wheel added to the Shopsmith), fitting the felt, and fitting a ton of miniature junk into the chest (and its neighbor)
.Thanks for watching!
Chris
- Chest Montage.JPG (77.35 KiB) Viewed 1173 times
Re: Pulled out my Mini Sled for some Tiny Drawers
Posted: Sat Nov 06, 2021 10:13 am
Looks great! I love these older wooden cabinets such as this Gerstner.