Page 6 of 6
Re: New forum member
Posted: Thu Nov 25, 2021 9:29 pm
by JPG
No my opinion has not changed. I accepted it as valid from the get go.
I did not remember the fourth pix when I commented above. It sets the table 90° stop.
Re: New forum member
Posted: Sun Nov 28, 2021 7:43 am
by Gumpy
G'day, Gumpy here from South Eastern Ontario, Canada! I am pretty new to this wood working thing... But setting up my shop to the best I can... As of so far I have a table saw, 9" bandsaw, 10" miter saw, lathe, and jointer, and planner...and air compressor... Still looking for few more tools... But I am looking to learn, and meet some friends around here... So cheers everyone...
Gumpy....