Shopsmith Forums

I've been waiting to find these new clamps in stock somewhere so I could order them. Well it happened!

https://www.axminstertools.com/us/festo ... rrency=USD

A pair of them doesn't get you to the free shipping threshold so beware the shipping is expensive but if you have a few other things you might want then add them to get to that point.

One thing I added was this:

https://www.axminstertools.com/us/axcal ... mps-101972

This bit should allow you to use your festool clamps in the t-slot it cuts. When it comes I will verify that. That is still not enough so you will have to find some other things to buy to get to the $120 amount for free shipping. Also keep in mind this is a 1/2" shank so you have to have a suitable router.

Ed

In anticipation of the new clamps I have updated my tool rack on the kapex stand with more holes and a place for a Combination Square. I want to add a pencil rack sometime but have not decided on a design yet. Perhaps have place to hold a tape measure as well.
I think I showed this hear before but can't find the thread???

Ed