Shopsmith Forums

a MKV500 or MK510 lol

Probably 500 upgraded to the 510 main table and carriage. Then he put the old 500 carriage on the left side of the headstock but I can't tell exactly what's mounted there. Apparently his 500 main table, with maybe part of it cut off or just covered up in the top picture. That's a 500 fence on that table, and extension tables don't mount in the carriage.

It's a Frankensmith!

jsburger wrote: Wed May 04, 2022 3:55 pm It's a Frankensmith!

---------------

Like !!
The SS has more diversity than any table saw I own.

edma194 wrote: Wed May 04, 2022 3:38 pm Probably 500 upgraded to the 510 main table and carriage. Then he put the old 500 carriage on the left side of the headstock but I can't tell exactly what's mounted there. Apparently his 500 main table, with maybe part of it cut off or just covered up in the top picture. That's a 500 fence on that table, and extension tables don't mount in the carriage.

----------------

pretty close , there are extension tables in their mounts along with the 500 and 510 table . the fence acted as a stop for the bed headboards and the 6x6 beams we used in the rental we made a few years back . the miter saw was clamped rock solid to the 510 table , it was perfect fit to the base of the miter saw , I am a hoarder for a reason lol .

I was going to say it is a real fancy Miter Saw stand.

I was thinking he misplaced his Shopsmith Miter Gauge...

b

chapmanruss wrote: Thu May 05, 2022 12:57 pm I was going to say it is a real fancy Miter Saw stand.

-------------

it makes a really good one !! If I had the room I would buy a base just for the miter saw and make a mini for the smaller miter saw lol it would be a little heavy to be made portable but for a shop it works as long as the stock isnt too long when cutting on a angle . lol and it got the 500 table off the floor !