Page 2 of 2
Re: Raising saw table to clear blade before sliding table
Posted: Sun Sep 11, 2022 12:57 pm
by stew
Thanks for the tip, the finger touch method worked for my 520 system.
Re: Raising saw table to clear blade before sliding table
Posted: Sun Sep 11, 2022 9:15 pm
by Matanuska
Should have said I have a 520 table.
Re: Raising saw table to clear blade before sliding table
Posted: Mon Sep 12, 2022 12:18 pm
by rogersk
Matanuska wrote: ↑Sun Sep 11, 2022 9:15 pm
Should have said I have a 520 table.
I was disappointed it didn't work for my Model 500, but it's still a good tip. If I ever get a 520, I'll be using it. Thanks for posting it.
Re: Raising saw table to clear blade before sliding table
Posted: Mon Sep 12, 2022 1:41 pm
by JPG
Keep in mind the original M5 design was for a 9" blade and the MV 500 for a 10" blade. I do not think the MV 500 mounting posts are different from the M5. That means an additional 1/2" elevation is required.
Re: Raising saw table to clear blade before sliding table
Posted: Sun Sep 18, 2022 1:42 am
by jwwrguru
For people who ponder the acquisition of a slide... They are superior to a normal table saw. My saw is almost no degree in comparison to a few of the more extensive and higher-quality slides I've utilized, but the same guidelines hold.
Re: Raising saw table to clear blade before sliding table
Posted: Sun Sep 18, 2022 1:16 pm
by db5
jwwrguru wrote: ↑Sun Sep 18, 2022 1:42 am
For people who ponder the acquisition of a slide... They are superior to a normal table saw. My saw is almost no degree in comparison to a few of the more extensive and higher-quality slides I've utilized, but the same guidelines hold.
What does "acquisition of a slide" refer to?
Re: Raising saw table to clear blade before sliding table
Posted: Sun Sep 18, 2022 1:40 pm
by JPG
spam coming!