Shopsmith Forums

I see Nick has a nice article on the adjustable finger joint jig, in the March issue of Popular Woodworking. Great to see and read him. Sad that he is not with Shopsmith.

Sweet so good to see him again. I was happy to see that he is working again. I remember that jig. Too bad he isn't using a SS anymore.

I didn't recall seeing any recent article in Popular Woodworking by Nick, however after doing a bit of research and going through some of my past issues, I finally found the story - the February 2007 issue. Here is a link to it for all that are interested.

http://www.popularwoodworking.com/artic ... Joint_Jig/

rkh2 wrote:I didn't recall seeing any recent article in Popular Woodworking by Nick, however after doing a bit of research and going through some of my past issues, I finally found the story - the February 2007 issue. Here is a link to it for all that are interested.

http://www.popularwoodworking.com/artic ... Joint_Jig/

It appears the jig shown was built for BOTH 1/4" AND 3/4".

I did not realize he had done another aritcle there when I said I remembered
seeing the jig I was reffering to
http://www.shopsmithacademy.com/SS_Arch ... _Index.htm

Jig in article AND sawdust session are the same.

Thanks everyone for clarifying Nick's piece on Popular Woodworking. I did not notice that it was an old article. His reference did not make any mention of Shopsmith, so I assumed it was his new status.

Sorry if I confused everyone. What is Nick doing anyway?