Page 1 of 1
Rip Cutting Wide Boards with Angle
Posted: Fri Apr 03, 2009 3:49 pm
by Len
OK, it's not really THAT wide, standard 1 x 12", and I want to put a 20* angle cut on both of the edges so that the top is 9 1/4" wide. I tilt the table to 20 degrees but my fence does not grab to hold. Any suggestions would be most appreciated. Very frustrating.
Posted: Fri Apr 03, 2009 4:24 pm
by paul heller
Len, what do you mean by the fence will not hold? Is it because the table is too short? Here's what I do. Move the headstock all the way to the right of the machine, and use an extension table with tubes to form a longer table that will allow you to position the fence further away from the blade.
Paul
Posted: Fri Apr 03, 2009 6:10 pm
by Len
What's that, you say? There are too many trees in this place to find the forest.
I forgot that I had them! Came with the 520 table upgrade, so now I get a chance to really use them!
What's that official OED entry? DUHO
!:o
Thank you, Paul.
"Why do all those things that happen to stupid people keep happening to me?" -Homer Simpson.