Does anyone 3D print a table insert for the 555220 scroll saw?

[raymondbrown]

Does anyone 3D print a table insert for the 555220 scroll saw? If you're out there please let me know. Otherwise I'll be making some out of some birch plywood that I hope I still have.

Thanks in advance.

[edma194]

Isn't that the same as 516173, the insert for the aluminum bandsaw table?

[chapmanruss]

It depends on which table it has. There were two different Tables for the gray Model 555220 Scroll Saw. The early Table used an insert (P/N 515196) similar, but not the same, as the Cast Iron Table Bandsaw. The later Table used a very similar insert (P/N 516061) but different in the opening for the blade then the Aluminum Table Bandsaw Insert (P/N 516173). The Insert from the Aluminum Table Bandsaw will fit the later Scroll Saw Table.

This is the early Table gray Scroll Saw.

_

Model 555220 ser Apr 14 1989.jpg (98.22 KiB) Viewed 8659 times

.
This is the later Table gray Scroll Saw.

_

Model 555220 Scroll Saw - gray - Mark Mount.jpg (129.41 KiB) Viewed 8659 times

[edma194]

I bought a package of PowerTec bandsaw zero clearance inserts a while back for the cast iron bandsaw table. They are 2-1/2" OD X 2-3/16" ID and fit will with a smidgeon of filing around the outside edge. If the scroll saw table is close they may work.