Page 1 of 1
Re: Does anyone 3D print a table insert for the 555220 scroll saw?
Posted: Thu Dec 21, 2023 12:27 am
by edma194
Isn't that the same as 516173, the insert for the aluminum bandsaw table?
Re: Does anyone 3D print a table insert for the 555220 scroll saw?
Posted: Thu Dec 21, 2023 12:37 pm
by chapmanruss
It depends on which table it has. There were two different Tables for the gray Model 555220 Scroll Saw. The early Table used an insert (P/N 515196) similar, but not the same, as the Cast Iron Table Bandsaw. The later Table used a very similar insert (P/N 516061) but different in the opening for the blade then the Aluminum Table Bandsaw Insert (P/N 516173). The Insert from the Aluminum Table Bandsaw will fit the later Scroll Saw Table.
This is the early Table gray Scroll Saw.
_
- Model 555220 ser Apr 14 1989.jpg (98.22 KiB) Viewed 9259 times
.
This is the later Table gray Scroll Saw.
_
- Model 555220 Scroll Saw - gray - Mark Mount.jpg (129.41 KiB) Viewed 9259 times
Re: Does anyone 3D print a table insert for the 555220 scroll saw?
Posted: Thu Dec 21, 2023 1:58 pm
by edma194
I bought a package of
PowerTec bandsaw zero clearance inserts a while back for the cast iron bandsaw table. They are 2-1/2" OD X 2-3/16" ID and fit will with a smidgeon of filing around the outside edge. If the scroll saw table is close they may work.
Table Insert for 555220 Scroll Saw
Posted: Wed Jun 25, 2025 7:36 am
by MODERATOR
NB: The original poster was a spammer and the original post has been deleted.
Re: Does anyone 3D print a table insert for the 555220 scroll saw?
Posted: Thu Jun 26, 2025 1:04 pm
by JPG
?????