Page 1 of 1
DC3300 FINALLY repaired.
Posted: Sun May 10, 2009 12:53 am
by beeg
I finally repaired my DC3300, the bolt that holds the impeller broke AGAIN. I finally had to drill the old bolt out and run tap through it to make sure the threads were good. I tried to use an ez-out, but found out the threads were messed up. WHAT a MESS when ya have to take the hood off.
Posted: Sun May 10, 2009 6:22 am
by dusty
beeg wrote:I finally repaired my DC3300, the bolt that holds the impeller broke AGAIN. I finally had to drill the old bolt out and run tap through it to make sure the threads were good. I tried to use an ez-out, but found out the threads were messed up. WHAT a MESS when ya have to take the hood off.
Yes, it is a mess. I hope you wore a mask while doing the dusty task.
I am glad that you were able to recover from this failure. Hopefully, this fix shall be a lasting one.