Page 1 of 1
turning faceplate for ER10?
Posted: Fri Jun 12, 2009 10:47 am
by sasjzl
I am trying to find out where I need to look to get lathe holding accessories like a faceplate and multi jaw holder for a Shopsmith 10ER.
Thanks very much,
Jim Lee
Posted: Fri Jun 12, 2009 10:52 am
by JPG
sasjzl wrote:I am trying to find out where I need to look to get lathe holding accessories like a faceplate and multi jaw holder for a Shopsmith 10ER.
Thanks very much,
Jim Lee
The current Mark V issue should work. They have a 5/8" bore for the spindle shaft.