Page 1 of 1
Anyone turning on a 10ER?
Posted: Fri Jul 31, 2009 9:02 pm
by sasjzl
Has anyone out there done any turning on a 10ER? I am just starting to turn and wanted to know if there are any hints or tips I should know about. Is there a way to slow the speed down with getting the coveted speed reducer setup?
Thanks very much,
Jim Lee
Posted: Fri Jul 31, 2009 9:31 pm
by wlhayesmfs
http://groups.yahoo.com/group/Shopsmith10ERusers/
There is a lot of us out there doing that and if you go to this group and you will find a lot of others turning with them. I turn with an ER, 510 and also Rikon lathe. You will find a lot of good uses for your ER.
Good luck, and enjoy using a different machine.
Anyway without Yahoo
Posted: Sat Aug 01, 2009 2:38 pm
by sasjzl
Is there any way I can look at this list without signing up for Yahoo?
Thanks very much,
Jim Lee
Posted: Sat Aug 01, 2009 4:03 pm
by JPG
sasjzl wrote:Is there any way I can look at this list without signing up for Yahoo?
Thanks very much,
Jim Lee
Why not just go ahead and "sign up"! Won't cost you anything!:)
Posted: Sat Aug 01, 2009 5:30 pm
by fjimp
[quote="JPG40504"]Why not just go ahead and "sign up"! Won't cost you anything!:) ]
I agree yahoo provides one more source for a ton of terrific information. Its fee and works well. fjimp
Posted: Sat Aug 01, 2009 5:59 pm
by wlhayesmfs
That is where I can met most of these guys even before here. Like they say it is free and you will learn a ton.
er turning
Posted: Thu Sep 17, 2009 3:49 am
by woodshaper
I do all my pen turning on a 10e and I also have a 10er, would not trade them for the world. My 10e has a speed changer on it that comes in handy on certain turnings,and I also belong to the yahoo group, wealth of nollage and a great bunch of guys that can help with all sorts of stuff.