Page 1 of 1
Finishing maple
Posted: Sat Sep 12, 2009 1:02 am
by rdewinter
I finished some maple breadboard finger pulls with a Minwax honey oak stain, sealer and finish. I wasn't real happy with the results, as it appeared blochy, kind of like pine without a pre stain sealer. Now a couple of months later, the color and finish appears to be gone. Any suggestions on the staining of maple? Would a darker color of stain be better?
Bob
San Diego
Posted: Sat Sep 12, 2009 9:19 am
by enyoc
Posted: Sat Sep 12, 2009 10:58 am
by Ed in Tampa
Having lived and died staining maple cabinets for my Master bath I have learned many lessons. The first with maple before you do anything give it a coat of shellac. Bullseye makes a shellac primer that is dewaxed (avail at Lowes and Home Depot) that is perfect for this.
The Shellac primer coat seems to prevent the blotchiness and seems to make the stain more uniform and easier to apply.
Another lesson I learned was to give each coat of finish plenty of drying time. I mean a day between coats. Even the shellac which dries almost instantly was better if left for a full day before I tried staining or applying a finish.
If you are using Minwax polystain (good luck) apply very very light coats allow them to completely dry and then apply the next. If you don't allow enough drying time the second coat will lift the first. If you apply any coat too heavy you will end up with streaks that are almost impossible to get out without stripping the wood down to nothing and starting over.
Ask me how I know? I played around with the finish on my cabinets for almost 6 weeks. I know I stipped everything off of them at least twice. Resanded and began again.
Posted: Mon Sep 14, 2009 10:07 am
by rdewinter
JC
The maple I used is not strongly figured, but the videos you referenced are a big help. Thank you. I'm going to try some of the tips in the videos.
Bob
San Diego