Shopsmith Forums

I have this model 640 Magna 6'' belt sander that I am repairing and looking for a parts diagram that shoes how it goes together and how to adjust it. I have all the parts to it, but need it to put it back together. also needs welding done to it, one side is broken in two places. Also what is a good way to clean the aluminum. I read some where on here that they used braso and a wheel that looks like it was plasic. If any one can point me in the right direction I would be real happy.

Clyde

MERRY CHRISTMAS

http://www.shopsmith.com/ownersite/part ... xpview.htm


Video Link

http://www.shopsmithacademy.com/SS_Arch ... Tuneup.htm

This should get you started.

Thanks for the link I looked for it but did not fine it, must of not looked hard enough.

Clyde

Hi Clyde,

Here's the link to my posting on using Brasso and a Weiler, coarse nylon cup brush attached to my 3/8" drill to clean up my sander.

http://www.shopsmith.net/forums/showthr ... 635&page=3

It's working great now.

Edit added: Mike reminded me to be sure and wear a respirator or at least a dust mask. Of course, you need good eye protection also.

Jerry Floren
St. Peter, MN

bluekayak wrote:Hi Clyde,

Here's the link to my posting on using Brasso and a Weiler, coarse nylon cup brush attached to my 3/8" drill to clean up my sander.

http://www.shopsmith.net/forums/showthr ... 635&page=3

It's working great now.

Edit added: Mike reminded me to be sure and wear a respirator or at least a dust mask. Of course, you need good eye protection also.

Jerry Floren
St. Peter, MN

Thanks Bluekayak

Clyde
And Merry Christmas