Page 1 of 1
tool help
Posted: Tue Jan 19, 2010 9:13 pm
by kameljoe21
here is something i got with some SS parts i ordered on ebay
i have now clue what it is
maybe you might
has no markings on it and there are 2 that are the same
thanks
Posted: Tue Jan 19, 2010 9:24 pm
by kartoffelkopf
Those sure look to be a pair of kickback pawls for a tablesaw. -Missing the mounting/splitter assembler. (Are there prizes for winning?):D
Posted: Tue Jan 19, 2010 9:47 pm
by kameljoe21
do you have a pic of what they would look like compleat
i still not sure what im looking at
edit i also have 2 sets of round disk than i think are saw blade balancers
ill post another pic
there are 2 sets
ones red 5/8 hole no markings ones gray 1/2 hole markings is ID-5000-53-31
i know what i think there for ther some type of balancer for small saw blades
lower left hand corner is the grey one
Posted: Wed Jan 20, 2010 2:36 am
by nomoman
http://www.shopsmith.com/ownersite/part ... xpview.htm
Check out part #199. The items on the side are the kickback pawls. This might give you some sort of visual what kartoffelkopf is talking about.
tool help
Posted: Wed Jan 20, 2010 6:18 am
by dusty
Yes, they do look like kickback pawls but they are not for the Shopsmith Upper Saw Guard.
This is a picture of a saw guard that I have with pawls that look very much like what is in question.
[ATTACH]7465[/ATTACH]
[ATTACH]7466[/ATTACH]
Don't be confused by the set up. This saw guard is clamped to the top of my WorkMate for the photo shoot only.
Posted: Wed Jan 20, 2010 9:17 am
by kameljoe21
ok that what i was thinking that they were i just never have seen them
ok now on to the other items of the round disk
i posted the description up above with an edit
