Page 1 of 1
Trade Miter Gauge “Quick Clamp” Retro-fit Kit
Posted: Sat Feb 27, 2010 12:44 am
by paulmcohen
I am looking to trade a new (unopened package) 555125,
Miter Gauge “Quick Clamp” Retro-fit Kit for a reasonable condition 5/8" 520 table saw arbor. No rusty junk please.
If you are interested PM me.
Posted: Sat Feb 27, 2010 9:08 am
by dusty
paulmcohen wrote:I am looking to trade a new (unopened package) 555125,
Miter Gauge “Quick Clamp” Retro-fit Kit for a reasonable condition 5/8" 520 table saw arbor. No rusty junk please.
If you are interested PM me.
Paul, my suggestion to you is to order direct from Shopsmith. That way you are assured that you get "NO RUSTY JUNK". Beggars and Choosers - what do they say about that?
Posted: Sat Feb 27, 2010 12:36 pm
by fjimp
dusty wrote:Paul, my suggestion to you is to order direct from Shopsmith. That way you are assured that you get "NO RUSTY JUNK". Beggars and Choosers - what do they say about that?
Paul I must agree with Dusty on that one. I tried a used one and still mutter every time I open the drawer where it is stored. Jim
Posted: Sat Feb 27, 2010 4:32 pm
by paulmcohen
That still leave me with a new, unopened miter gauge upgrade that I did buy directly from Shopsmith, plus shipping on one small item is very high.
If I don't get to trade I will just wait for a sale.
Posted: Sun Feb 28, 2010 12:46 am
by paulmcohen
Ok, since it turns out I have no 5/8 arbors I ordered one tonight. $40 each was a little steep.