Page 1 of 1
5/8 Arbor Question
Posted: Sun Feb 28, 2010 12:05 pm
by juneaudave
I bought a couple used 5/8" arbors off Ebay for my Model 500. They came with rubber gaskets, but are too big for the arbors....
What are the gaskets for? Are they the one's that fit on the quill?
Posted: Sun Feb 28, 2010 12:15 pm
by wlhayesmfs
I cannot tell how thick they are but I vote yes on fitting the quill
Posted: Sun Feb 28, 2010 12:25 pm
by juneaudave
Thanks Bill...they look to be a good 1/8" thick or so. Does the spacer gasket on the quill ever wear out?
Posted: Sun Feb 28, 2010 12:58 pm
by charlese
I'm with Bill! Do they wear out? Don't think so, but maybe they can stretch, and become loose.
Posted: Sun Feb 28, 2010 1:14 pm
by reible
Hi,
The rubber spacer was a replacement for the aluminum spacer when you upgraded from the metal lower saw guard to the plastic ones. Yes it mounts on the quill, between the headstock and the ring on the quill.
I don't know if these are current part numbers but the rubber spacer was 501307 and the aluminum one was 555070.
Ed
Posted: Sun Feb 28, 2010 4:03 pm
by SDSSmith
juneaudave wrote:I bought a couple used 5/8" arbors off Ebay for my Model 500. They came with rubber gaskets, but are too big for the arbors....
What are the gaskets for? Are they the one's that fit on the quill?
They are rubber spacer washers intended to be installed between certain lower saw guards and the quill. I do not recall which guards required the spacer washer.