I recently inherited a vintage Shopsmith Mark VII and when I was checking it out I noticed a lose, roughly, v-shaped, spring inside the power head. I believe it is related to the inter latch spring. Can someone tell me how this can be put back into place or direct me to a page with information that will help ?
Thanks in advance - rijjb3
inter latch release spring ?
Moderators: HopefulSSer, admin
Sorry! Don't know a thing about the Mark VII. Was able to find this link for you. From info in this link, you will be able to order a manual for the Mark VII. Hope it helps!
http://www.shopsmith.com/ownersite/item ... tem=877083
http://www.shopsmith.com/ownersite/item ... tem=877083
Octogenarian's have an earned right to be a curmudgeon.
Chuck in Lancaster, CA
Chuck in Lancaster, CA
Hi,
Sorry I don't know much about the Mark VII. Have you posted this request at the http://www.ssug.org site? They have a section setup on that machine and that might be another good place to visit as I know some people there have that machine.
This link will take you to the MK VII area:
http://www.ssug.org/forums/viewforum.php?f=8
Ed
Sorry I don't know much about the Mark VII. Have you posted this request at the http://www.ssug.org site? They have a section setup on that machine and that might be another good place to visit as I know some people there have that machine.
This link will take you to the MK VII area:
http://www.ssug.org/forums/viewforum.php?f=8
Ed