Mark VII - Need Some Parts
Posted: Mon Jun 14, 2010 8:46 am
I was able to pick up a Mark VII yesterday at an auction, but it will need a bit of work before cutting some wood, etc. The motor runs, both forward and reverse, and the speed dial raises and lowers the speed; however, the speed increases and the dial turns on its own with the motor running. There was a wooden wedge jammed between the speed dial and the headstock to keep the speed from advancing on its own. I haven't gotten into the headstock yet other than check to see that the cam looked ok, so hopefully it's an easy fix. Any ideas?
It also was missing a few parts that are specific to the machine. There was no rip fence or small table. I though perhaps the rip fence from a Mark V would fit, but the Mark VII's table is a couple of inches deeper than the Mark V's. Anyone have any spares?
There was no tailstock, sanding disk, lathe centers or saw arbor, but the Mark V's will fit, so no problem there.
There is one crack/split in the rack for advancing the headstock, but the crank works smoothly and that break in the rack doesn't seem to be a problem. The vacuum has suction, so that seems to work as well. And, it also came with the flexible shaft.
With tax and a buyer's premium it came to about $110, so not too bad a deal in my view, provide I can come up with the rip fence and small table. It's still on the back of the pick-up, so I'll be unloading and giving it a better look later today.
It also was missing a few parts that are specific to the machine. There was no rip fence or small table. I though perhaps the rip fence from a Mark V would fit, but the Mark VII's table is a couple of inches deeper than the Mark V's. Anyone have any spares?
There was no tailstock, sanding disk, lathe centers or saw arbor, but the Mark V's will fit, so no problem there.
There is one crack/split in the rack for advancing the headstock, but the crank works smoothly and that break in the rack doesn't seem to be a problem. The vacuum has suction, so that seems to work as well. And, it also came with the flexible shaft.
With tax and a buyer's premium it came to about $110, so not too bad a deal in my view, provide I can come up with the rip fence and small table. It's still on the back of the pick-up, so I'll be unloading and giving it a better look later today.