Page 1 of 1
Pro Planer In and Out Feed Roller Replacement
Posted: Mon Oct 11, 2010 2:22 pm
by keepatightline
I must replace the outfeed roller on my model 514300 pro planer but I don't see how to remove it without removing the back side plate. Does anyone know the "trick" needed to avoid complete disassembly? Thanks in advance.
Posted: Mon Oct 11, 2010 2:58 pm
by SDSSmith
The replacement rollers come with instructions. Did you lose them?
Posted: Mon Oct 11, 2010 3:13 pm
by SDSSmith
To be clear, are you trying to avoid removing the planer from the stand or ?? Hopefully, you have the instructions that Shopsmith includes with the replacement rollers. If not, email me.
Posted: Wed Oct 13, 2010 10:01 am
by keepatightline
First, thank you for responding. Facts are I was just trying to find out how to "lift out" the roller. I tried getting it out through the trapazoid shapes but was repeatedly unsuccessful. HOWEVER, this morning I walked out with a cup of coffee in one hand, barely awake, and got lucky. It lifted right out through that opening. I think I'm set for now. Again, thanks for responding.
Posted: Wed Oct 13, 2010 6:15 pm
by tunznath
Hi
I think I may have to replace one in the near future, so any OTHER info will be much appreciated
thanks