replaced the Control Sheave Assembly bearing
Posted: Tue Nov 09, 2010 6:28 am
i replace the bearing in the end of the pully with another type for pictures email me at rf58@yahoo.com it wasn't eazy but it works.
my pictures are to big to download . i think i may have lost a little on the slow speed because of the size bolt i used to make the ring clip on the end .
WHEN i pushed the bearing in it PUT a hairline cracke in the pully = so i made a ring to press over it. i'm saving my money and will probably buy a new one some day =maybe santa will bring one . but untill then IT WORKS.
my pictures are to big to download . i think i may have lost a little on the slow speed because of the size bolt i used to make the ring clip on the end .
WHEN i pushed the bearing in it PUT a hairline cracke in the pully = so i made a ring to press over it. i'm saving my money and will probably buy a new one some day =maybe santa will bring one . but untill then IT WORKS.