Shopsmith Forums

I was able to download the pics off of my camera card. the tool holder is a design of a fellow ShopSmith owner and I must defer credit to him!!

I finished gluing the other side up with the dowels installed, tonight

looking good! i would like to see it fully assembled also. don't know that i have ever seen dowels in a dado joint. should be strong enough to drive a truck over.

i'll get some pics of the finished unit in the morning. it works really good, but i need to hollow the dimples for the back end of the tools, as the they're not quite deep enough...

thanks, bill

brick1 wrote:I was able to download the pics off of my camera card. the tool holder is a design of a fellow ShopSmith owner and I must defer credit to him!!

I finished gluing the other side up with the dowels installed, tonight

Can you post a link to the original designer??

brick1 wrote:i'll get some pics of the finished unit in the morning. it works really good, but i need to hollow the dimples for the back end of the tools, as the they're not quite deep enough...

thanks, bill

Why 'dimples'. Flat bottomed counter bore(non-through forstner hole)not OK? Or a 1/2" mdf with through holes?

here's a partial side view of the finished project on the way tubes. the wood is scrap from a local restorer of "woody station wagons and cars". i like using dowels on little projects like this because i like the "contrast" of wood colors. i made a bunch of earings for the ladys in my family, about fifteen years ago. i used three colors glued together and then hand cut and finished. my older hands dont take kindly to that kind of miniture work anymore.....

take care, bill

That turned out real nice Bill I can't wait to see your first pen now

Hey Paul, i guess you know i have a couple of kits that will be forthcoming!!!

the mandrel should be here in a couple of days.......then its off and runnin!!

i got a trash can full of scraps from that "woody" shop and as soon as i get a few minutes to see what treasures he threw out, i'll let you know!!

take care, bill

JPG40504 wrote:Why 'dimples'. Flat bottomed counter bore(non-through forstner hole)not OK? Or a 1/2" mdf with through holes?

i have a commerical die grinder from race engine days, and the carbide bits need a little use now and then.....and it keeps my skills up!! i like free form a lot and practice it every chance i get..

thanks again, bill

navycop wrote:Can you post a link to the original designer??

just as soon as i can locate it again, i will. that was a very intense reading time for me, right after my new/used SS was sitting in the shop. i cant remember what section it was in at the moment, but i'm going back through my older hard drive/one remaining brain cell, and see if i can find it.... i spent several weeks reading and learning, and trying to apply what worked for different folks to my smaller shop situation. mine is almost a duplicate of his, with the length of mine different than his. i made mine with a little more depth to have a few more inches on the way bars for different length projects. it leaves enough spaces to configure the ends of some more files, or buy more tools...

thanks, bill