Shopsmith Forums

Hi!

I don't know where to ask for this...

I've got a 510 floating table. But just the table without anything attached to it. No side tubes, locking screw, spacer...

So I'm looking for somebody that has the side tubes with everything needed to complete my floating table. Maybe somebody that upgraded from 510 to 520 and have those parts not used.

The parts are:
2x #247
2x #246
4x #245
4x #249
4x #248
I think that's all... I only have #243.

From this exploded view:
http://www.shopsmith.com/ownersite/part ... xpview.htm

Thx!

NB: I got a US address if shipping to Canada is not possible...

Tell us what part of the country you live (fill out your personal profile (or at least part of it)) and you just might find someone here on the forum that can help. I know that there have been a lot of 520 upgrades sported here. Each one of those results in a harvest of unused parts like you need.

I have all of the parts you need. Just send me a noteand we'll coordinate.

Thank you all!

I did not expect that much response! I was pleasantly surprised to see this forum is that active to fellow shopsmithers...

I got the parts in hand and I can now use the table extension I have.

Thx!

Well, guess I was a little late in reading this post... Otherwise you could have had my older 510 rail parts for the shipping cost.

Never the less happy to hear you were fully supported by forum members.