Page 1 of 1
1/4 sherline lathe cutters
Posted: Thu Jan 13, 2011 4:36 pm
by holsgo
I needed 3/8 cutters but I got 1/4 HSS. Anyone out there have a need for a set of 5 cutters?
Posted: Fri Jan 14, 2011 12:38 am
by horologist
I use either 3/8" or 1/8" so can't help but am surprised the Sherline can handle the 3/8".
Some time ago I bought a set of these:
http://www1.mscdirect.com/CGI/NNSRIT?PMPXNO=2250894&PMT4NO=0
when MSC had them on sale and have been very happy with them.
Troy
Posted: Fri Jan 14, 2011 5:46 am
by holsgo
What happened was I mistakenly bid on a 1/4 set on ebay. I actually need 3/8. Contacted the seller and they said all sales final. Great but I didn't pay alot and will re-ebay them if I can't find a taker.
Posted: Fri Jan 14, 2011 10:44 am
by efmaron
Depending on your tool holder, can you put an 1/8" shim under the 1/4" tool bit so that you can still use the ones you bought.
Posted: Fri Jan 14, 2011 1:06 pm
by holsgo
I ordered new (used in need of sharpening) ones off ebay. I thought about the shim but it would take 2, one under and one on the side since it's 3/8 x 3/8.