Page 1 of 1
Table Saw blade
Posted: Tue Jan 25, 2011 7:46 pm
by andes
Hello, was wondering if someone could tell me if there is a good blade out there that I could purchase. I was hoping to find a high teeth count blade that would work with my mark V. Looking for something higher then a 80 tooth.
Posted: Tue Jan 25, 2011 7:53 pm
by beeg
Why ya want a > 80 tooth blade?
Posted: Tue Jan 25, 2011 11:21 pm
by ddvann79
andes,
Do you have a 1-1/4" saw arbor or 5/8"?
Here's the basic
Shopsmith blade selection with descriptions of the blades and their uses. Be sure to watch the
videoon that page for choosing saw blades. It's got a lot about geometry, types, and particulars.
Shopsmith also offers
Amana blades and one of them is an 80-tooth plastics blade. These are commercial-grade with 1-1/4" arbor holes.
And of course,
Freudis a well-respected brand.
Are you looking to cut plastics or melamine? The number of teeth also depend upon the diameter of the blade, but I'm assuming you're looking for a 10".
Posted: Tue Jan 25, 2011 11:48 pm
by pennview
Since you want a blade with that many teeth, I'll assume you want a good cross cutting blade. The Freud LU85 10" blade fits that bill. It has 80 teeth that will give you splinter free cross cuts in solid wood. If you want something to rip or cut other material, you'll need to look at some other blade.
Posted: Wed Jan 26, 2011 8:30 am
by Fla_Jim
I use a forty tooth "Forrest woodworker II". I think it's the best blade I've ever used.
For about eleven bucks Forrest will bore it out to an inch and a quarter to fit a shopsmith arbor, or use it with the 5/8" arbor.
Forrest blades
Posted: Wed Jan 26, 2011 10:30 am
by jimsjinx
Yep, I can't afford more than one, but the woodworker II series is a great blade. I had it sharpened locally, and even though ten years old, it is as good as new. Absolute polished edges on a crosscut. Uses less energy to cut,too! But they are proud of them! Over a hundred bucks even on sale. jimsjinx