Page 1 of 1
"New" part machine.
Posted: Thu Mar 24, 2011 8:28 am
by jcraigie
Yesterday I picked up a new machine to use for parts. We're also going to you any cash we raise by selling parts to buy more Shopsmith stuff that we need. I gave $50 for it, not bad but it is in rough shape. It was being used as a metal lathe.
This is a cross vise that bolts to the way tubes and whole load of different drill chucks.
[ATTACH]12377[/ATTACH]
[ATTACH]12378[/ATTACH]
Posted: Thu Mar 24, 2011 8:31 am
by jcraigie
[attach]12379[/attach]
[attach]12380[/attach]
Posted: Thu Mar 24, 2011 8:33 am
by jcraigie
When I go there he immediatly started it up and it ran beautiful and smooth but look at the cord! No way would I run it with that cord.
[ATTACH]12381[/ATTACH]
Posted: Thu Mar 24, 2011 8:34 am
by jcraigie
Not sure what happened to the piece on the end of the quill
[ATTACH]12382[/ATTACH]
Posted: Thu Mar 24, 2011 8:38 am
by dusty
You got your money's worth in chucks and you have a great machine to be used for a restoration to say nothing about the vise.
Power cord looks great too.
:rolleyes:
Posted: Thu Mar 24, 2011 8:39 am
by jcraigie
I did get a jig saw in decent shape. Where do I get blades for this? I know some of you guys have a solution blades.[ATTACH]12384[/ATTACH]
[ATTACH]12385[/ATTACH]
[ATTACH]12386[/ATTACH]
[ATTACH]12387[/ATTACH]
[ATTACH]12388[/ATTACH]
[ATTACH]12384[/ATTACH]
Posted: Thu Mar 24, 2011 8:41 am
by jcraigie
Various other "modified" parts.
[ATTACH]12389[/ATTACH]
[ATTACH]12390[/ATTACH]
[ATTACH]12391[/ATTACH]
[ATTACH]12392[/ATTACH]
Posted: Thu Mar 24, 2011 8:46 am
by jcraigie
The vent plate... an early 1955
[ATTACH]12395[/ATTACH]