Weekly Blog - September 23rd
Posted: Sun Sep 23, 2007 4:56 pm
This past week has been a glorious end to summer in these parts, almost too nice to be inside!
However, I did get a bit of time in the shop and after last week's disappointment with the CD cabinet, decided to go for a change of pace and started some toys. I cut out the shapes for four small tractor trailer type trucks from a piece of old 2 x 4 scrap I had around. It is so old, it actually measured 1 5/8" in thickness, while current 2 x4 around here is now 1 1/4" thick.
The trucks originate from a Winfield design for a transport van that I adapted to make a series of flatbeds that can be made into tankers, loggers, or just a flatbed with side rails, etc. This occurred a few years ago when I found the wood I had was not wide enough (4") to make a transport so I cut out some flatbeds and started adding accessories.
Of the four cut out this past week, two will be loggers (one is finished) and I have not decided yet on the other two. I will try to post pictures when I get a complete set of four.
Have a good and safe week!
John
However, I did get a bit of time in the shop and after last week's disappointment with the CD cabinet, decided to go for a change of pace and started some toys. I cut out the shapes for four small tractor trailer type trucks from a piece of old 2 x 4 scrap I had around. It is so old, it actually measured 1 5/8" in thickness, while current 2 x4 around here is now 1 1/4" thick.
The trucks originate from a Winfield design for a transport van that I adapted to make a series of flatbeds that can be made into tankers, loggers, or just a flatbed with side rails, etc. This occurred a few years ago when I found the wood I had was not wide enough (4") to make a transport so I cut out some flatbeds and started adding accessories.
Of the four cut out this past week, two will be loggers (one is finished) and I have not decided yet on the other two. I will try to post pictures when I get a complete set of four.
Have a good and safe week!
John