Page 1 of 1
Vessel turning system
Posted: Wed Sep 07, 2011 9:27 am
by robinson46176
I had not seen this system before but thought it looked interesting...
http://www.carterproducts.com/hollowroller/
.
Posted: Wed Sep 07, 2011 11:50 am
by JPG
How da ya keep the finished turning from leaking?:D Plastic bag liner?:rolleyes:
Posted: Wed Sep 07, 2011 6:21 pm
by damagi
Interesting that you bring this up, because I turned up this thread earlier today:
http://www.shopsmith.net/forums/showthr ... est+rotate
Talks about adapting an Elbotool to the shopsmith:
http://www.elbotool.com/
I also recall seeing on youtube a DIY version:
http://www.youtube.com/watch?v=xNuiXiNp ... ideo_title
Posted: Wed Sep 07, 2011 9:56 pm
by charlese
JPG40504 wrote:How da ya keep the finished turning from leaking?:D
Easy!!! Just don't put anything into it.
Posted: Thu Sep 08, 2011 9:42 am
by pennview
Penn State Industries has a clamping-style toolrest similar to the one in the Carter system but I don't know how substantial it is, but something like that certainly will give you better control over turning inside a deep vessel.
Posted: Thu Sep 08, 2011 9:56 am
by damagi