Page 1 of 1
Does anyone have a spare 3326 chuck for sale?
Posted: Fri Oct 07, 2011 10:25 am
by justsomeguy
I've been hunting high and low for a used 3326 drill chuck for my SS but it has apparently been discontinued.
This is a shot in the dark, but what the heck. Does anyone happen to have an extra they are willing to let go at a good price for a junior woodworker?
Thanks!
Steve
Posted: Fri Oct 07, 2011 10:38 am
by beeg
Well this one will work and it gives ya a price to compare others to.
http://www.shopsmith.com/ownersite/catalog/dr_chuck.htm
Posted: Fri Oct 07, 2011 10:49 am
by justsomeguy
Thanks Bob - it's hard to tell from that photo - does it have the set screw to mount it directly to the spindle?
Cheers!
Steve
Posted: Fri Oct 07, 2011 11:04 am
by JPG
justsomeguy wrote:Thanks Bob - it's hard to tell from that photo - does it have the set screw to mount it directly to the spindle?
Cheers!
Steve
It does!
3326's can be found on e-bay almost all days. They are
usually much less $$.
Posted: Fri Oct 07, 2011 11:27 am
by cincinnati
JPG40504 wrote:It does!
3326's can be found on e-bay almost all days. They are usually much less $$.
Not today. Used is the same price as SS and new double.
Posted: Fri Oct 07, 2011 1:28 pm
by JPG
cincinnati wrote:Not today. Used is the same price as SS and new double.
Patience Grasshopper. Last week there were several.
This is a Goldie vintage Jacobs '
MC8K26' which will also work quite well.
http://www.ebay.com/itm/Shopsmith-Mark-V-Jacobs-Multi-Craft-Drill-Chuck-MC8K26-W-key-/170698123298?pt=LH_DefaultDomain_0&hash=item27be66a822
It too is priced too high.
Wait till more reasonable fare is offered.
Posted: Fri Oct 07, 2011 7:27 pm
by justsomeguy
Many thanks. I'll keep my eye open for a reasonably priced solution.
I *do* have a jacobs chuck, but it's a 1/2" threaded spindle. I use it with a SS arbor and it works fine, but the threaded section is far too long to use the mortising attachment.
Posted: Fri Oct 07, 2011 9:09 pm
by JPG
justsomeguy wrote:Many thanks. I'll keep my eye open for a reasonably priced solution.
I *do* have a jacobs chuck, but it's a 1/2" threaded spindle. I use it with a SS arbor and it works fine, but the threaded section is far too long to use the mortising attachment.
http://www.ebay.com/itm/SHOPSMITH-5-8-HOLE-1-2-DRILL-CHUCK-/260864606767?pt=LH_DefaultDomain_0&hash=item3cbcbe022f
There are a couple of others now! This one should clean up nicely(a little evaporust...).