Page 1 of 1
Shopsmith 2 bearing quill?
Posted: Thu Nov 17, 2011 9:02 pm
by mustangpalmer1911
Posted: Thu Nov 17, 2011 9:33 pm
by SDSSmith
I would ask the seller if it is a two bearing quill or what the part number is. But if you have the Gilmer drive, you are going to need a few more parts to make this quill work.
Posted: Fri Nov 18, 2011 9:04 am
by mustangpalmer1911
P/N is the 2 bearing quill so for 32 bucks I jumped on it quicker than me on fresh chocolate cookies out of the oven.
Posted: Fri Nov 18, 2011 9:52 am
by nuhobby
Well.... it could be the PO's leftover 1-bearing quill after they put the new quill in their existing machine...
Posted: Fri Nov 18, 2011 12:31 pm
by JPG
mustangpalmer1911 wrote:P/N is the 2 bearing quill so for 32 bucks I jumped on it quicker than me on fresh chocolate cookies out of the oven.
I do hope the seller provided an accurate answer, but I have to wonder where the seller acquired the info. The description did not indicate to me much knowledge on the part of the seller.
Here's hoping ya got lucky!:)
P.S. Closer examination of the pix indicates it has had some use(marks at ends of anti-rotation groove, and set screw marks on shaft).