Shopsmith Forums

Posted: **Wed Dec 21, 2011 4:14 pm**

Hi I'm new to the forum. I have a shopsmith piece I have no clue what it is. So I'm hopeing someone can tell me. It is 2 channels black hinged on one end, the other end has a black handel. Their is a small guid near the hinge that reads degrees from 0 to 15 and inches per foot from 0 to 3. Their is a curved guid on the side with a wing nut to adjust the opening.
I hope I explained it well.
Thanks

Posted: **Wed Dec 21, 2011 4:23 pm**

a picture is worth a thousand words, but you just described the taper jig for the table saw

Posted: **Wed Dec 21, 2011 4:24 pm**

WELCOME to the forum tjf1socal. Can ya provide a pic?

Posted: **Wed Dec 21, 2011 4:39 pm**

bettyt44720 wrote:a picture is worth a thousand words, but you just described the taper jig for the table saw

I think you nailed it!

Shopsmith Forums

question on a tool

question on a tool