Page 1 of 1
Rare Item!
Posted: Sun Jan 15, 2012 3:50 pm
by JPG
This ShopSmith item is so rare that they spelled the name differently!:rolleyes:
http://www.ebay.com/itm/Rare-Shopsmith- ... 20c1544395
It will fit a M10 though(and just about everything else out there)!:D
Posted: Sun Jan 15, 2012 9:35 pm
by wiredone
Posted: Sun Jan 15, 2012 9:50 pm
by JPG
Posted: Mon Jan 16, 2012 12:11 pm
by wiredone
Still haven't sold any of these, although the price is much more realistic.
http://www.ebay.com/itm/140680490697?ss ... 1555.l2649
Posted: Mon Jan 16, 2012 1:28 pm
by JPG
Hey! Why
not make a ss pin for a M5/V? Ya would only have to drill one teeny tiny hole in 5/8" ss rod(polished and chamfered).
Ya could probably get $59.95 for them!:D
Posted: Mon Jan 16, 2012 8:54 pm
by wiredone
It's already in the works. I want one for my Greenie that's going back together soon.
I don't think I've ever seen a non-rusted factory one!
People for the most part don't realize just how expensive stainless rods are.
I'll shoot a pic and post it when I get er done.
Posted: Tue Jan 17, 2012 12:37 pm
by wiredone
That pin on my Greenie is 3/4", are the later ones different? I think I could retail them for 24.95. Think they would sell?
Posted: Tue Jan 17, 2012 1:49 pm
by JPG
wiredone wrote:That pin on my Greenie is 3/4", are the later ones different? I think I could retail them for 24.95. Think they would sell?
OK! 3/4" My Bad!:o
I am skeptical!
Drill a 1/4-20 centered hole in each end and sell them as double tilt pins.
Trouble is, they never wear out or break!
Posted: Tue Jan 17, 2012 7:49 pm
by wiredone
They never wear out but they always rust.
I am ordering some stainless hardware for a dress up on the greenie, I'll put together some kits and see what happens.