Shopsmith Forums

This one just showed up today...

http://greenville.craigslist.org/tls/2867483154.html

mountainbreeze wrote:This one just showed up today...

http://greenville.craigslist.org/tls/2867483154.html

I normally do not pay that amount for unknown condition or 50s Shopsmiths. I try to stay under a $100 maximum unless there are a lot of additional items, accessories and/or SPTs included.

I noticed this one showed up on craigs list yesterday. It is not a unit but a scroll saw with table for $40.00. Just don't know if I need it or not. But I think it definitely is priced right!

Can this be used as a regular SPT if you put the tubes back on it??

http://austin.craigslist.org/tls/2867049496.html

Thanks,

aloibl wrote:I noticed this one showed up on craigs list yesterday. It is not a unit but a scroll saw with table for $40.00. Just don't know if I need it or not. But I think it definitely is priced right!

Can this be used as a regular SPT if you put the tubes back on it??

http://austin.craigslist.org/tls/2867049496.html

Thanks,

Outstanding buy. I am sure you could get the parts needed (back ordered and not too cheap) to convert it to a regular SPT. If you do buy it, I would be interested in swapping you the parts you would need to convert to a regular SPT. Too far for me to buy it.

Bill Mayo