Page 1 of 1
Woodsmith Shop Project
Posted: Sun Feb 26, 2012 11:38 am
by mountainbreeze
I had some scrap walnut and oak that I wanted to do something with and this project form Woodsmith Shop was just right. Here's the results.
[ATTACH]16451[/ATTACH]
[ATTACH]16450[/ATTACH]
Posted: Sun Feb 26, 2012 11:49 am
by Gene Howe
Nice looking box!
Well done.
Posted: Sun Feb 26, 2012 1:15 pm
by STB
[quote="mountainbreeze"]I had some scrap walnut and oak that I wanted to do something with and this project form Woodsmith Shop was just right. Here's the results.
[ATTACH]16451[/ATTACH]
QUOTE]
The outside end appears tapered with a cove at the top. How did you cut the taper and cove?
Posted: Sun Feb 26, 2012 3:25 pm
by mountainbreeze
For the most part, I followed the instructions. Here is the pictorial of how to shape the sides:
[ATTACH]16452[/ATTACH]
For more details, go
here and check out Season 5 Episode 502.
Posted: Sun Feb 26, 2012 3:41 pm
by robinson46176
From all appearances the process worked very well for you.
.
Posted: Sun Feb 26, 2012 9:25 pm
by judaspre1982
========================
Posted: Mon Feb 27, 2012 7:52 am
by mbcabinetmaker
That looks way to good to have been made in Greer SC.
Glad to see that you are enjoying your 520.
Posted: Mon Feb 27, 2012 11:40 am
by JPG
[quote="mbcabinetmaker"]That looks way to good to have been made in Greer SC.]
Hmmmmm! I could, but I won't!:D
Nice 'box'!
Posted: Mon Feb 27, 2012 10:58 pm
by mrhart
I saw that show and put the box on my "to do" list as well. Nice job sir.
