Doggy steps part 2
Posted: Mon May 27, 2013 4:45 pm
Doggy steps continued.
I used a V grove router bit to countersink the tapered bolts the taper angle was a little off but close enough. Something happened I don't understand some of the counter sync did not follow the predrilled holes but kind of made it's own path to the side making a less than craftsman look.
[ATTACH]21605[/ATTACH]
[ATTACH]21606[/ATTACH]
We are now in Klamath Falls, Oregon. It is 48 deg. Just went from rain to hail then sleet back to rain now sunshine. We are having fun now.
This is a view of the steps in use at the Klamath KOA. After looking at the picture a thought just occurred to me. If the stringers were a little thicker maybe 1 3/4 in we could use the steps and maybe I could make some husband points with SWMBO.
[ATTACH]21607[/ATTACH]
I used a V grove router bit to countersink the tapered bolts the taper angle was a little off but close enough. Something happened I don't understand some of the counter sync did not follow the predrilled holes but kind of made it's own path to the side making a less than craftsman look.
[ATTACH]21605[/ATTACH]
[ATTACH]21606[/ATTACH]
We are now in Klamath Falls, Oregon. It is 48 deg. Just went from rain to hail then sleet back to rain now sunshine. We are having fun now.
This is a view of the steps in use at the Klamath KOA. After looking at the picture a thought just occurred to me. If the stringers were a little thicker maybe 1 3/4 in we could use the steps and maybe I could make some husband points with SWMBO.
[ATTACH]21607[/ATTACH]