Shopsmith Forums

I just became a proud owner of a Shopsmith Mark V yesterday. I am very excited to get using it. I have already put a blade on the table saw and fired it up. Now is where I have a problem.

The Blade is stuck on the spindle! I can't get it off for the life of me. I have unscrewed the little screw but it just won't budge. Anyone have any suggestions on getting the darn blade off of the spindle????

Take a look at aprevious posting

Pay attention to Bill Mayo's advise in post #7

Oh, yea. Welcome to the forum...

Many thanks for the link! I knew there had to be a thread here about it I just couldn't find it. I will give it a try & hopefully it will work.

albie wrote:Take a look at aprevious posting

Pay attention to Bill Mayo's advise in post #7

Oh, yea. Welcome to the forum...

Man, that was VERY helpful.

I really liked Nick's post. In fact, I just "favorite"d his website.

steve