Page 1 of 1
Toy finishing
Posted: Mon Aug 29, 2011 10:08 am
by mrhart
Hello all, there is alot of info out there about what to finish toys with. What I have is a couple of simple toys (post pics soon) that I have sanded and rattle canned shelac with, about 3 coats. I steel wooled one a little and it made it alot smoother.
Do I stop where I'm at, or steel wool and spray again? or leave them smooth after the steel wool?:rolleyes:
Posted: Mon Aug 29, 2011 12:47 pm
by beeg
Three coats and a final steel wooling should be enough.
Posted: Mon Aug 29, 2011 12:52 pm
by mrhart
Thank you sir, so steel wooling is the "final step" correct?
Posted: Mon Aug 29, 2011 2:00 pm
by Gene Howe
After sanding the finish with 300, I steel wool with non oiled #0000 then vacuum, the get some Johnson's paste wax on the wool and go over it again.
Posted: Mon Aug 29, 2011 2:02 pm
by mrhart
Thankyou for the tips guys, I have 0000 and I'll grab some wax at Lowes this afternoon.
Thanks again:)
Posted: Mon Aug 29, 2011 2:06 pm
by beeg
I'd skip the wax, because it's going to a child.
Posted: Mon Aug 29, 2011 8:26 pm
by john
I'm with the other guys.
I have made a bundle of toys and used different finishes but shellac and a rub down with #oooo steel wool is one of my favourites.
Have fun
John
Posted: Tue Aug 30, 2011 7:04 am
by foxtrapper
Remember too, mothers will be very concerned for safety for their kids, so things like shellac and others that are edibly safe will be the preferred finish.
Posted: Tue Aug 30, 2011 9:03 am
by tom_k/mo
Another thing you might want to concider for kids toys is an oil finish that's specifically made for Salad Bowls. It's food safe and would not hurt the kids.
Posted: Tue Aug 30, 2011 9:38 am
by beeg
NO FINISH works too.