Shopsmith Forums

That looks like the shaft guard to put over the shafts on the left side when your not using them.

When I powered it up I wasn't using an extension cord, the house power should be good since I don't have problems with any of the other tools, I'm thinking once I get everything cleaned and properly lubricated it will run just fine.

Thank you guys very much for your help. I have I lathe I like that I have been using for about years so not sure how much turning I will do since I am already invested in the chucks for that. I needed replace an old table saw that had the motor freeze up so that is why I bought this. I like to make ...

That is a very scary video! After watching this I will spend extra time making sure the blade guard is installed correctly and I under how to use it before I use the saw.

I wasn't sure what to take a picture of so here are a few of what I bought for $200. I assume this is a 500. The handle to move the quill feed lever looks like it is in a dangerous position, I hope that is adjustable! I did turn power it up and it does run, seems to take a little time to get up to s...

Hi, I new to SS but have done some lathe work. I just picked up mark v. And have been reading through the manuals, cheching ou this site and going through the parts that came with it to see what I have gotten into. How can I tell what the model is? The invoice shows it was bought in 1982 / part no. ...