Search found 441 matches
- Fri Jul 26, 2024 10:14 pm
- Forum: Maintenance and Repair
- Topic: New Member starting Restoration
- Replies: 25
- Views: 780
Re: New Member starting Restoration
I've always bought belts from Shopsmith, their sizes are not readily available though there are one or more ebay sellers that carry replacements. That said, people here have recently reported receiving a BESTORQ 4L260 for the motor belt. As far as I'm concerned the jury is out on the performance of...
Re: way tubes
Trim the bench tubes to eliminate the gap in the way tubesJPG wrote: ↑Tue Jul 23, 2024 9:27 pmTrim off??? 3/8" spacers needed at each end(tubes need to be longer?)HopefulSSer wrote: ↑Tue Jul 23, 2024 12:57 pm I think I'd be inclined to trim off enough to eliminate the gap
Re: way tubes
I think I'd be inclined to trim off enough to eliminate the gap
- Sun Jul 21, 2024 12:51 pm
- Forum: Maintenance and Repair
- Topic: New Member starting Restoration
- Replies: 25
- Views: 780
Re: New Member starting Restoration
As far as the 510 or 520 model , I am still learning , reading this forum and watching u tube. How do I tell the difference? Both 510s and 520s use steel tubes to support floating tables. On 510s, those tubes fit within other steel tubes that are attached to the tables. On 520s however, the support...
- Sun Jul 07, 2024 8:42 pm
- Forum: Maintenance and Repair
- Topic: markv drive belt size
- Replies: 10
- Views: 8046
- Sun Jul 07, 2024 6:18 pm
- Forum: Maintenance and Repair
- Topic: markv drive belt size
- Replies: 10
- Views: 8046
- Sun Jul 07, 2024 6:17 pm
- Forum: Maintenance and Repair
- Topic: markv drive belt size
- Replies: 10
- Views: 8046
Re: markv drive belt size
Yes there are arguments for and against here in the archives. Seems like Bill Mayo ultimately decided that the wear is not excessive enough to be concerned about. I'll run it for a little while and see how it goes. I may end up going back to a conventional belt. But I was not happy with the one I go...
- Sun Jul 07, 2024 5:31 pm
- Forum: Maintenance and Repair
- Topic: markv drive belt size
- Replies: 10
- Views: 8046
Re: markv drive belt size
This is the belt I got from SS last year. I just now replaced it with a link belt and like the link belt better so far....
- Sun Jul 07, 2024 4:39 pm
- Forum: Maintenance and Repair
- Topic: Belt specs vary
- Replies: 11
- Views: 33475
Re: Belt specs vary
I've installed the link belt. With it, I get RPM from 500-5000 (+/- a few tens of RPM). This is the belt that I installed on the machine last year, brand new from Shopsmith. It's 0.49" wide. I felt like with it, the speed control was non-linear at the slow end. It seemed like from "slow&qu...
- Sun Jul 07, 2024 1:21 pm
- Forum: Maintenance and Repair
- Topic: Belt specs vary
- Replies: 11
- Views: 33475
Re: Belt specs vary
Reviving an old thread... I was reading threads here by Bill Mayo and others about switching to a link belt. I have a green one of unknown origin that I just measured for width and it's right at 0.543". Out of curiosity and to compare, I dug out a couple of used belts I had in a box. Both were ...