Does anyone have a spare 3326 chuck for sale?

justsomeguy · Post by **justsomeguy** » Fri Oct 07, 2011 10:25 am

I've been hunting high and low for a used 3326 drill chuck for my SS but it has apparently been discontinued.

This is a shot in the dark, but what the heck. Does anyone happen to have an extra they are willing to let go at a good price for a junior woodworker?

Thanks!

Steve

beeg · Post by **beeg** » Fri Oct 07, 2011 10:38 am

Well this one will work and it gives ya a price to compare others to.

http://www.shopsmith.com/ownersite/catalog/dr_chuck.htm

justsomeguy · Post by **justsomeguy** » Fri Oct 07, 2011 10:49 am

Thanks Bob - it's hard to tell from that photo - does it have the set screw to mount it directly to the spindle?

Cheers!

Steve

JPG · Post by **JPG** » Fri Oct 07, 2011 11:04 am

justsomeguy wrote:Thanks Bob - it's hard to tell from that photo - does it have the set screw to mount it directly to the spindle?

Cheers!

Steve

It does!

3326's can be found on e-bay almost all days. They are usually much less $$.

cincinnati · Post by **cincinnati** » Fri Oct 07, 2011 11:27 am

JPG40504 wrote:It does!

3326's can be found on e-bay almost all days. They are usually much less $$.

Not today. Used is the same price as SS and new double.

JPG · Post by **JPG** » Fri Oct 07, 2011 1:28 pm

cincinnati wrote:Not today. Used is the same price as SS and new double.

Patience Grasshopper. Last week there were several.

This is a Goldie vintage Jacobs 'MC8K26' which will also work quite well.http://www.ebay.com/itm/Shopsmith-Mark-V-Jacobs-Multi-Craft-Drill-Chuck-MC8K26-W-key-/170698123298?pt=LH_DefaultDomain_0&hash=item27be66a822

It too is priced too high.

Wait till more reasonable fare is offered.

justsomeguy · Post by **justsomeguy** » Fri Oct 07, 2011 7:27 pm

Many thanks. I'll keep my eye open for a reasonably priced solution.

I *do* have a jacobs chuck, but it's a 1/2" threaded spindle. I use it with a SS arbor and it works fine, but the threaded section is far too long to use the mortising attachment.

JPG · Post by **JPG** » Fri Oct 07, 2011 9:09 pm

justsomeguy wrote:Many thanks. I'll keep my eye open for a reasonably priced solution.

I *do* have a jacobs chuck, but it's a 1/2" threaded spindle. I use it with a SS arbor and it works fine, but the threaded section is far too long to use the mortising attachment.

http://www.ebay.com/itm/SHOPSMITH-5-8-HOLE-1-2-DRILL-CHUCK-/260864606767?pt=LH_DefaultDomain_0&hash=item3cbcbe022f

There are a couple of others now! This one should clean up nicely(a little evaporust...).