Woodsmith Shop Project

mountainbreeze · Post by **mountainbreeze** » Sun Feb 26, 2012 11:38 am

I had some scrap walnut and oak that I wanted to do something with and this project form Woodsmith Shop was just right. Here's the results.

[ATTACH]16451[/ATTACH]

[ATTACH]16450[/ATTACH]

Gene Howe · Post by **Gene Howe** » Sun Feb 26, 2012 11:49 am

Nice looking box!
Well done.

STB · Post by **STB** » Sun Feb 26, 2012 1:15 pm

[quote="mountainbreeze"]I had some scrap walnut and oak that I wanted to do something with and this project form Woodsmith Shop was just right. Here's the results.

[ATTACH]16451[/ATTACH]

QUOTE]
The outside end appears tapered with a cove at the top. How did you cut the taper and cove?

mountainbreeze · Post by **mountainbreeze** » Sun Feb 26, 2012 3:25 pm

For the most part, I followed the instructions. Here is the pictorial of how to shape the sides:

[ATTACH]16452[/ATTACH]

For more details, go here and check out Season 5 Episode 502.

robinson46176 · Post by **robinson46176** » Sun Feb 26, 2012 3:41 pm

From all appearances the process worked very well for you.

.

judaspre1982 · Post by **judaspre1982** » Sun Feb 26, 2012 9:25 pm

========================

mbcabinetmaker · Post by **mbcabinetmaker** » Mon Feb 27, 2012 7:52 am

That looks way to good to have been made in Greer SC.

Glad to see that you are enjoying your 520.

JPG · Post by **JPG** » Mon Feb 27, 2012 11:40 am

[quote="mbcabinetmaker"]That looks way to good to have been made in Greer SC.]
Hmmmmm! I could, but I won't!:D

Nice 'box'!

mrhart · Post by **mrhart** » Mon Feb 27, 2012 10:58 pm

I saw that show and put the box on my "to do" list as well. Nice job sir.