Mark7 idler shaft nut

woodnutty · Post by **woodnutty** » Thu Mar 22, 2012 9:36 am

Hi to all Anybody know what size the nut is that holds the idler shaft in place on a mark7? Hopefully its not a specialty item Thanks Woodnutty

mikemarkvii · Post by **mikemarkvii** » Thu Mar 22, 2012 5:22 pm

I beleive that it a 21/32 -11tpi r.h. if you are referring to a mark VII. don't know about the mark 7. Or rather it fits my sawsmith arbor [rh] if anybody knows where to find a left hand nut, i would really appreciate that knowledge.

now i need to clean up 5 inches of snow. it NEVER snows in wesrern or
mike