I admit to not being much of a turner, but I wanted to do a little fancier pen turning and I found that my regular pen mandrel that I was using for the 7mm pens was just not working for me. I wanted to turn just the glue-up between centers. I split a mandrel leaving about 3/4" on each end for insertion into the brass cylinder. The combination seems to work well for me. I am sure others have used this setup or one that works better. Pics of the modified mandrel, glue-up and pens for comment.
ldh
[ATTACH]16836[/ATTACH]
[ATTACH]16837[/ATTACH]
[ATTACH]16838[/ATTACH]
[ATTACH]16839[/ATTACH]
Split Mandrel
Moderator: admin
Split Mandrel
- Attachments
-
- DSCN2600.JPG (37.64 KiB) Viewed 785 times
-
- DSCN2602.JPG (59.12 KiB) Viewed 786 times
-
- DSCN2592.JPG (109.17 KiB) Viewed 785 times
-
- DSCN2590.JPG (121.46 KiB) Viewed 787 times
-
terrydowning
- Platinum Member
- Posts: 1678
- Joined: Mon Jul 19, 2010 3:26 pm
- Location: Windsor, CO
Can't argue with the results.
For Turning tubes between centers, I made a 60 degree dead center out of oms maple scrap I had. Making a new on out of some acetal (delrin) I came across. I'll post photos of my setup when done.
I use my collet chuck to hold the dead center.
For Turning tubes between centers, I made a 60 degree dead center out of oms maple scrap I had. Making a new on out of some acetal (delrin) I came across. I'll post photos of my setup when done.
I use my collet chuck to hold the dead center.
--
Terry
Copy and paste the URLs into your browser if you want to see the photos.
1955 Shopsmith Mark 5 S/N 296860 Workshop and Tools
https://1drv.ms/i/s!AmpX5k8IhN7ahFCo9VvTDsCpoV_g
Public Photos of Projects
http://sdrv.ms/MaXNLX
Terry
Copy and paste the URLs into your browser if you want to see the photos.
1955 Shopsmith Mark 5 S/N 296860 Workshop and Tools
https://1drv.ms/i/s!AmpX5k8IhN7ahFCo9VvTDsCpoV_g
Public Photos of Projects
http://sdrv.ms/MaXNLX