And, I saw a good one the other day. Near the west side Lowe's and HD is a cabinet supplier. Got to go in there.
Here's why....
Moderator: admin
-
swampgator
- Platinum Member
- Posts: 1256
- Joined: Fri Nov 27, 2009 9:32 pm
- Location: Pensacola, FL
We have 3 of each HD and Lowe's. All the Lowe's have people at the check out stands. In HD, you may get a cashier as they are pressuring us to use the self check outs. I can't hear them and I don't know how to operate one, so I always look for a store where there is a live person. Like calling someone on the phones these days with the automated systems and their definitions that make you wonder which button to push. I just pound the heck out of the "0" until a person comes on.
And, I saw a good one the other day. Near the west side Lowe's and HD is a cabinet supplier. Got to go in there.
And, I saw a good one the other day. Near the west side Lowe's and HD is a cabinet supplier. Got to go in there.
Steve, the old Florida gator
I just love it when she says I can go make sawdust.

I just love it when she says I can go make sawdust.
-
paulmcohen
- Platinum Member
- Posts: 1578
- Joined: Fri Dec 08, 2006 8:10 pm
- Location: Beaverton, Oregon
- Contact:
Just finished my other shop improvement project, a winch to assist movement SPT's.
[ATTACH]17007[/ATTACH]
My kids helped and it was a lot harder then I though, the winch is heavy and awkward. I am a little scared that the garage door rail is not strong enough to hold the weight. It is held into the wall studs by 5" lag bolts so I don't think it will pull out but I am not sure the rail won't bend.
Assuming it holds I am on to finishing the lathe chisel holder by added a second set of 4" deep doors that will hold another set of chisels and some of the larger ones that don't fit.
[ATTACH]17007[/ATTACH]
My kids helped and it was a lot harder then I though, the winch is heavy and awkward. I am a little scared that the garage door rail is not strong enough to hold the weight. It is held into the wall studs by 5" lag bolts so I don't think it will pull out but I am not sure the rail won't bend.
Assuming it holds I am on to finishing the lathe chisel holder by added a second set of 4" deep doors that will hold another set of chisels and some of the larger ones that don't fit.
- Attachments
-
- IMG_0236.JPG (113.25 KiB) Viewed 384 times
Paul Cohen
Beaverton, OR
A 1982 500 Shopsmith brand upgraded to a Mark 7 PowerPro, Jointer, Bandsaw (with Kreg fence), Strip Sander, Ring Master and lots of accessories all purchased new
12" Sliding Compound Mitre Saw, 1200 CFM DC
Beaverton, OR
A 1982 500 Shopsmith brand upgraded to a Mark 7 PowerPro, Jointer, Bandsaw (with Kreg fence), Strip Sander, Ring Master and lots of accessories all purchased new
12" Sliding Compound Mitre Saw, 1200 CFM DC